How to change ignition coils on Mercedes-Benz 2.0T 4-Cylinder M274 M270 engine
By YOUCANIC onMay 24, 2019
In this guide, you will find instructions on how to change the ignition coils on 2013 and newer Mercedes-Benz models equipped with the four cylinders 2.0-liter turbo engine. See application list below.
Park your Mercedes-Benz on a level ground set the parking brake and let the engine cool down.
Pull the hood release under the dashboard to open the hood.
Remove the engine cover by lifting it up.
Remove the T-25 Torx bolts that secure the ignition coil to the engine. Each ignition coil has two bolts.
Disconnect the electrical connector. Use a flathead screwdriver to unlock the tab on the connector. Then press and pull the connector away.
If your ignition coil comes with the boot, pull up the coil and the boot togther to remove them from the spark plugs. If you are not replacing the boot, use a flathead screwdriver to pry out the spark plug boot from the ignition coil. Pull up the ignition coil.
Remove the ignition coil.
Install the new ignition coil and torque the Torx screws to 10Nm.
Help us improve this article by submitting a comment. All feedback, suggestions, comments, and corrections are welcomed.
💡 Need Help?
Join our community to get help with your car questions, show off your ride, connect with car enthusiasts, mechanics and more. It's easy, fast and free. 👉 Continue
Disclaimer: Youcanic has made every effort to assure the accuracy of the information on this page. Neither Youcanic nor its affiliates assume responsibility for any loss or damage due to any errors, omissions, lack of information. You agree to hold Youcanic free from any liability arising out of the use of any information contained within. All pictures and references to trademarks and car names are for reference only and do not imply an association with the manufacturer. Consult your owner's manual or authorized factory manuals when performing repair procedures. By entering this site, you agree to our Terms & Conditions and Privacy Polity.